Operating Instructions:
WAH RANGEVOLUME CONTROL
The Wah Range Selector knob is located onBy turning the Volume Control knob located on the left side
the side of the 535Q pedal. It allows you to selectof the pedal, you control the amount of gain. Turning the knob
a tonal range that is best suited for your expres-clockwise will increase your gain to up to 16dB.Turning the knob
sion needs. Turn the knob clockwise for thecounter-clockwise will decrease your gain to 0dB, or normal
lower register ranges and counter-clock-throughput.
wise for the higher ranges.
VARIABLE Q
By rocking your foot back
The OQ� adjustment is also located on the left side of the
and forth on the pedal, you can
pedal; you can control the sharpness of the bandpass with this
change the effect that theadjustment. High Q is a very selective bandpass filter, low Q is a
535Q pedal has on the tone
very broad bandpass filter approaching an almost volume like
of your instrument instanta-
control. The lower Q settings have more musical quality and
neously.Toe down will give youdonOt effect tone as much as the high Q settings.
more treble; heel down will give
you more bass. The speed and
amount of effect you use depends
on your style of playing.
When placing the pedal in one posi-POWER REQUIREMENTS
tion, you will hear a boost in that particularThe CRYBABY¨ 535Q Wah Wah pedal uses one 9-volt battery.The battery access is
frequency.This boost can be used to add sus-through the bottom of the pedal.
The 535Q uses the Dunlop ECB03 Adapter (ECB03E for Europe),a 9-volt DC regu-
tain and create feedback of a desired overtone.lated AC adapter.Plug polarity is positive on the barrel and negative in the center.
NOTE:Battery must be installed to operate the 535Q unless an AC adapter is used.
When using a battery,the life of the battery can be greatly extended if you unplug the
input when the effect is not in use for long periods of time. |
ACEC
